How to VO Code Cruise Control on BMW F series

How to VO Code Cruise Control on BMW F series

How to VO Code 544 to enable Cruise Control in your BMW F series

Once you have installed the cruise control buttons on your steering wheel, you will need to code several blocks to activate this function.


1) Start your E-Sys, Click "Read" button and then "Active FA":

2)  Go to "SALAPA-Element" and right click and select "Edit":

3) Add the value "544," into the SALAPA-Element and click the save button on the right as highlighted.

4)  Click the "save" button to save the file into a XML file with your desired file name.

5) Go to "VCM" section and load the same XML file that you had saved.

6) Right click "calculate FP" and you will see the Vehicle Profile generated.

  

7) Click the "Write FA FP" button once you are satisfied with your settings which will writes into your ECU memory. 

8) To enable Cruise Control, you will need to VO code these

1) BDC_BODY

2) HU_ENTRYNAV

3) KOMBI (or  BKOMBI)

4) DSC2


9) Go to "Coding" section, click "Read ECU" button on the right and then right click on the above-mentioned modules and select "Code". This will enable the settings required for your Cruise Control. Note that the engine need not be switched off for this operation to work successfully.

10) Test your Cruise Control switch to ensure that it has been enabled successfully. Congratulations!

11) It is recommended to remove the VO Code after the coding has been performed.



If VO code is something that you don't prefer to modify, you can perform FDL codings only as such to enable Dynamic Cruise Control:



BDC_BODY

PfLinSteeringWheel -> 3140 > LIN_VARIANTE_MFL = DCC_Sports_SLD



HU_NBT 

EXBOX 3001 > DCC = aktiv 

DSC2

DSC_FAS_CODIERDATEN 3009 > C_Fahrfunktion = DCC